8) What command sets the range of network numbers associated with an AppleTalk network (用什么命令来设置与A p p l e Ta l k网络关联的网络号的范围)？ 

　　A. APPLETALK ZONE NAME 

　　B. APPLETALK CABLE-RANGE 

　　C. APPLETALK CABLE RANGE 

　　D. appletalk network-range 

　　9) Which of these protocols cannot be used for maintaining AppleTalk routing tables (下面协议中的哪一条不能用来维护A p p l e Ta l k路由表)？ 

　　A. RTMP 

　　B. AURP 

　　C. EIGRP 

　　D. IGRP 

　　10) How often does RTMP send out routing table updates (RT M P每隔多长时间发送一次路由选择表更新信息)？ 

　　A. Every 10 seconds 

　　B. Every 20 seconds 

　　C. Whenever a topology change occurs 

　　D. Every 30 seconds 

　　11) Which of the following commands is not necessary for a basic AppleTalk configuration (下面的哪条命令对基本的A p p l e Ta l k配置来说不是必需的)？ 

　　A. APPLETALK PROTOCOL RTMP 

　　B. APPLETALK CABLE-RANGE 1234-4321 

　　C. APPLETALK ZONE OZONE 

　　D. APPLETALK ROUTING 

　　12) What is the range of numbers used for AppleTalk access control filters (AppleTa l k访问控制过滤使用下面哪个数据范围)？ 

　　A. 100 ~ 299 

　　B. 500 ~ 699 

　　C. 600 ~ 700 

　　D. 600 ~ 699 

　　13) Which command displays the RTMP metrics (下面哪一条命令显示了RT M P的度量)？ 

　　A. SHOW TRMP 

　　B. show appletalk zone 

　　C. show appletalk metrics 

　　D. SHOW APPLETALK ROUTE 

　　14) If router A and router B are directly connected via their Serial 0 interfaces, which command would be most useful on router A for hiding zone President Zone (on the E0 interface) from router B (如果路由器A和路由器B通过Serial 0接口直接相连，路由器A上从路由器B隐藏President Zone域(在E 0接口)，哪一条命令是最有用的)？ 

　　A. APPLETALK ACCESS-GROUP 600 

　　B. appletalk zone-filter 600 

　　C. appletalk GETZONELIST-filter 600 

　　D. appletalk zip-reply-filter 600

上一页123456下一页