71. 用show ip pim neighbor显示PIM邻居表。
72. 显示组播通信路由表中的各条记录:
dallasr1>show ip mroute [group-name|group-address][scoure][summary][count][active kbps]
73. 要记录一个路由器接受和发送的全部IP组播包:
dallasr1> #debug ip mpacket [detail] [access-list][group]
74. 要在CISCO路由器上配置CGMP:
dallasr1>(config-if)# ip cgmp
75.配置一个组播路由器,使之加入某一个特定的组播组:
dallasr1>(config-if)# ip igmp join-group group-address
76. 关闭 CGMP:
dallasr1>(config-if)# no ip cgmp
77. 启动交换机上的CGMP:
dallasr1>(enable) set cgmp enable
78. 核实Catalyst交换机上CGMP的配置情况:
catalystla1>(enable) show config
set prompt catalystla1>
set interface sc0 192.168.1.1 255.255.255.0
set cgmp enable
79. CGMP离开的设置:
Dallas_SW(enable) set cgmp leave
80. 在Cisco设备上修改控制端口密码:
R1(config)# line console 0
R1(config-line)# login
R1(config-line)# password Lisbon
R1(config)# enable password Lilbao
R1(config)# login local
R1(config)# username student password cisco
81. 在Cisco设备上设置控制台及vty端口的会话超时:
R1(config)# line console 0
R1(config-line)# exec-timeout 5 10
R1(config)# line vty 0 4
R1(config-line)# exec-timeout 5 2
82. 在Cisco设备上设定特权级:
R1(config)# privilege configure level 3 username
R1(config)# privilege configure level 3 copy run start
R1(config)# privilege configure level 3 ping
R1(config)# privilege configure level 3 show run
R1(config)# enable secret level 3 cisco
83. 使用命令privilege 可定义在该特权级下使用的命令:
router(config)# privilege mode level level command
84. 设定用户特权级:
router(config)# enable secret level 3 dallas
router(config)# enable secret san-fran
router(config)# username student password cisco
① 凡本网注明稿件来源为"原创"的所有文字、图片和音视频稿件,版权均属本网所有。任何媒体、网站或个人转载、链接转贴或以其他方式复制发表时必须注明"稿件来源:我考网",违者本网将依法追究责任;
② 本网部分稿件来源于网络,任何单位或个人认为我考网发布的内容可能涉嫌侵犯其合法权益,应该及时向我考网书面反馈,并提供身份证明、权属证明及详细侵权情况证明,我考网在收到上述法律文件后,将会尽快移除被控侵权内容。